Viewing Detail Information Of The Interface - TP-Link T1600G-18TS Configuration Manual

Configuring Logical Interfaces
Valid Lifetime
Status

2.1.4 Viewing Detail Information of the Interface

In Figure 2-1 you can view the corresponding interface entry you create in the Interface
List section. On the corresponding interface entry, click Detail to load the following page
and view the detail information of the interface.
Figure 2-4 Viewing the detail information of the interface
2.2 Using the CLI
2.2.1 Creating a Layer 3 Interface
Follow these steps to create a Layer 3 interface. You can create a VLAN interface, a
loopback interface, a routed port or a port-channel interface according to your needs.
Step 1
Displays the valid lifetime of the global address.
Displays the status of the global address.
Normal: Indicates that the global address is normal.
Try: Indicates that the global address may be newly configured.
Repeat: Indicates that the global address is duplicate. It is illegal to access the
switch using this global address.
configure
Enter global configuration mode.
Logical Interfaces Configurations
Configuration Guide 383