Adding Mac Filtering Address Entries - TP-Link T1600G-18TS Configuration Manual

Managing MAC Address Table
Step 2 mac address-table aging-time aging-time
Set your desired length of address aging time for dynamic address entries.
aging-time:
the entry is used or updated. The valid values are from10 to 630. When 0 is entered, the Auto
Aging function is disabled. The default value is 300 and we recommend you keep the default
value if you are unsure about settings in your case.
Step 3 end
Return to privileged EXEC mode.
Step 4 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to modify the aging time to 500 seconds. A dynamic
entry remains in the MAC address table for 500 seconds after the entry is used or updated.
Switch#configure
Switch(config)# mac address-table aging-time 500
Switch(config)#show mac address-table aging-time
Aging time is 500 sec.
Switch(config)#end
Switch#copy running-config startup-config

2.2.3 Adding MAC Filtering Address Entries

Follow these steps to add MAC filtering address entries:
Step 1 configure
Enter global configuration mode.
Step 2 mac address-table filtering mac-addr vid vid
Add the filtering address to the VLAN.
mac-addr:
MAC address as the source address or destination address. The format is xx:xx:xx:xx:xx:xx, for
example, 00:00:00:00:00:01.
vid:
Step 3 end
Return to privileged EXEC mode.
Set the length of time that a dynamic entry remains in the MAC address table after
Specify a MAC address to configure the switch to drop packets which include this
Specify an existing VLAN in which packets with the specific MAC address are dropped.
Address Configurations
Configuration Guide 139