Adding Static Arp Entries Manually - TP-Link T1600G-18TS Configuration Manual

Configuring ARP

2.1.2 Adding Static ARP Entries Manually

You can add desired static ARP entries by mannually specifying the IP addresses and MAC
addresses.
Choose the menu Routing > ARP > Static ARP to load the following page.
Figure 2-2 Adding Static ARP Entries
Follow these steps to add static ARP Entries:
In the ARP Config section, enter the IP address and MAC address and click Create.
IP address
MAC address
2.2 Using the CLI
2.2.1 Configuring ARP Function
 Adding Static ARP Entries
Follow these steps to add ARP entries:
Step 1 configure
Enter global configuration mode.
Step 2 arp ip mac type
Add a static ARP entry.
ip
mac:
type:
Specify the IP address.
Specify the MAC address.
: Enter the IP address of the static ARP entry.
Enter the MAC address of the static ARP entry.
Enter the ARP type. Configure it as 'arpa'.
ARP Configurations
Configuration Guide 429