Configuring Max Group And Overflow Action On The Port - TP-Link T1600G-18TS Configuration Manual

Configuring Layer 2 Multicast
The following example shows how to enable Fast Leave on port 1/0/3:
Switch#configure
Switch(config)#ipv6 mld snooping
Switch(config)#interface gigabitEternet 1/0/3
Switch(config-if)#ipv6 mld snooping
Switch(config-if)#ipv6 mld snooping immediate-leave
Switch(config-if)#show ipv6 mld snooping interface gigabitEthernet 1/0/3 basic-config
Port MLD-Snooping
---- -------------
Gi1/0/3 enable
Switch(config-if)#end
Switch#copy running-config startup-config

Configuring Max Group and Overflow Action on the Port

Step 1 configure
Enter global configuration mode.
Step 2 interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | port-channel port-channel-id | range port-channe port-channel-list }
Enter interface configuration mode
Step 3 ipv6 mld snooping max-groups maxgroup
Enter the number of multicast groups the port can join. The range is 0 to 1000.
Step 4 ipv6 mld snooping max-groups action {drop | replace}
Specify the action towards the new multicast group when the number of multicast groups the
port joined exceeds max group.
drop: Drop all subsequent membership report messages, and the port join no more new
multicast groups.
replace: Replace the existing multicast group with the lowest multicast MAC address with the
new multicast group.
Step 5 show ipv6 mld snooping interface [fastEthernet [ port | port-list ] | gigabitEthernet [ port |
port-list ]] max-groups
Show the IGMP group limitation on the specified port(s) or of all the ports.
Step 6 end
Return to privileged EXEC mode.
Fast-Leave
----------
enable
Configuring MLD Snooping
Configuration Guide 326