TP-Link T1600G-18TS Configuration Manual page 570

Configuring Network Security
Choose the menu Network Security > IP-MAC Binding > ARP Scanning to load the
following page.
Figure 2-2 ARP Scanning
Follow these steps to configure IP-MAC Binding via ARP scanning:
1) In the Scanning Option section, specify an IP address range and a VLAN ID. Then click
Scan to scan the entries in the specified IP address range and VLAN.
Start IP Address/
End IP Address
VLAN ID
2) In the Scanning Result section, select one or more entries and configure the relevant
parameters. Then click Apply.
Host Name
IP Address
MAC Address
VLAN ID
Port
Protect Type
Source
Specify an IP range by entering a start and end IP address.
Specify a VLAN ID.
Enter a host name for identification.
Displays the IP address.
Displays the MAC address.
Displays the VLAN ID.
Displays the port number.
Select the protect type for the entry:
None: This entry will not be applied to any feature.
ARP Detection: This entry will be applied to the ARP Detection feature.
Displays the source of the entry.
IP-MAC Binding Configurations
Configuration Guide 547