Configuring Igmp Snooping Parameters On The Port - TP-Link T1600G-18TS Configuration Manual

Configuring Layer 2 Multicast
For switches that support MLD Snooping, IGMP Snooping and MLD Snooping share the
setting of Unknown Multicast, so you have to enable MLD Snooping globally at the same
time.
The following example shows how to configure the switch to discard unknown multicast
data:
Switch#configure
Switch(config)#ip igmp snooping
Switch(config)#ipv6 mld snooping
Switch(config)#ip igmp snooping drop-unknown
Switch(config)#show ip igmp snooping
IGMP Snooping
Unknown Multicast
Last Query Times
Last Query Interval
Global Member Age Time
Global Router Age Time
Global Report Suppression
Global Authentication Accounting:Disable
Enable Port:
Enable VLAN:
Switch(config-if)#end
Switch#copy running-config startup-config

2.2.4 Configuring IGMP Snooping Parameters on the Port

Configuring Router Port Time and Member Port Time
Step 1 configure
Enter global configuration mode.
Step 2 ip igmp snooping rtime rtime
ip igmp snooping mtime mtime
rtime
mtime
:Enable
:Discard
:2
:1
:260
:300
:Disable
is the aging time of router ports, ranging from 60 to 600 seconds.
is the aging time of member ports, ranging from 60 to 600 seconds.
IGMP Snooping Configurations
Configuration Guide 287