TP-Link T1600G-18TS Configuration Manual page 473

Configuring QoS
Broadcast
Rate Mode /
Broadcast
Multicast Rate
Mode / Multicast
UL-Frame Rate
Mode / UL-
Frame
LAG
2) Click Apply.
To enable the broadcast rate control, select a broadcast rate mode and specify
the upper rate limit for receiving broadcast packets in the Broadcast field. The
packet traffic exceeding the rate will be discarded.
The switch supports the following three rate modes:
kbps: Specify the upper rate limit in kilo-bits per second, which ranges from 1 to
1000000 kbps. This mode is invalid if PPS is enabled.
ratio: Specify the upper rate limit as a percentage of the bandwidth, which ranges
from 1 to 100 percent. This mode is invalid if PPS is enabled.
pps: Specify the upper rate limit in packets per second, which ranges from 1 to
1488000 packets per second. This mode is invalid if PPS is disabled.
To disable the broadcast rate control, select Disable in the Broadcast field.
To enable the multicast rate control, select a multicast rate mode and specify the
upper rate limit for receiving broadcast packets in the Multicast field. The packet
traffic exceeding the rate will be discarded.
The switch supports the following three rate modes:
kbps: Specify the upper rate limit in kilo-bits per second, which ranges from 1 to
1000000 kbps. This mode is invalid if PPS is enabled.
ratio: Specify the upper rate limit as a percentage of the bandwidth, which ranges
from 1 to 100 percent. This mode is invalid if PPS is enabled.
pps: Specify the upper rate limit in packets per second, which ranges from 1 to
1488000 packets per second. This mode is invalid if PPS is disabled.
To disable the multicast rate control, select Disable in the Multicast field.
To enable the UL-Frame (Unknown unicast frame) rate control, select a UL-Frame
rate mode and specify the upper rate limit for receiving UL-Frames in the UL-
Frame field. The packet traffic exceeding the rate will be discarded. The switch
supports the following three rate modes:
kbps: Specify the upper rate limit in kilo-bits per second, which ranges from 1 to
1000000 kbps. This mode is invalid if PPS is enabled.
ratio: Specify the upper rate limit as a percentage of the bandwidth, which ranges
from 1 to 100 percent. This mode is invalid if PPS is enabled.
pps: Specify the upper rate limit in packets per second, which ranges from 1 to
1488000 packets per second. This mode is invalid if PPS is disabled.
To disable the UL-Frame rate control, select Disable in the UL-Frame field.
Displays the aggregation group which the port is in.
Bandwidth Control Configuration
Configuration Guide 450