TP-Link T1600G-18TS Configuration Manual page 476

Configuring QoS
Step 3 Use the following commands to specify the upper rate limit of the broadcast packets, multicast
packets and unknown unicast frames in pps:
storm-control pps
Configure the storm control mode as pps (packets per second) on the port. In PPS mode, the
upper rate limit of the broadcast packets, multicast packets and unknown unicast frames can
only be specified in packets per second.
storm-control {broadcast | multicast | unicast} pps rate
broadcast | multicast | unicast:
unicast rate limit on the port.
rate:
unknown unicast frames on the port. The packet traffic exceeding the rate will be discarded.
The valid rate values are from 1 to 1488000 packets per second.
Use the following commands to specify the upper rate limit of the broadcast packets, multicast
packets and unknown unicast frames in kbps or ratio:
no storm-control pps
Ensure the pps mode is disabled on the port.
storm-control {broadcast | multicast | unicast} {kbps | ratio} rate
broadcast | multicast | unicast:
or unknown unicast frames rate limit on the port.
kbps:
in kilo-bits per second.
ratio:
as a percentage of the bandwidth.
rate:
unknown unicast frames on the port. The packet traffic exceeding the rate will be discarded.
For kbps, the valid rate values are from 1 to 1000000 kbps; for ratio, the valid rate values are
from 1 to 100 percent.
Step 4 show storm-control {interface [fastEthernet port | range fastEthernet port-list |
gigabitEthernet port | range gigabitEthernet port-list | port-channel lag-id | range port-
channel lag-list ]}
Verify the storm control configurations of the port or LAG. If no port or LAG is specified, it
displays the storm control configuration for all ports or LAGs.
Step 5 end
Return to privileged EXEC mode.
Step 6 copy running-config startup-config
Save the settings in the configuration file.
Specify the upper rate limit for receiving broadcast packets, multicast packets and
Configure the storm control mode as kbps. In this mode, the upper rate limit is specified
Configure the storm control mode as ratio. In this mode, the upper rate limit is specified
Specify the upper rate limit for receiving broadcast packets, multicast packets and
Enable broadcast rate limit, multicast rate limit or unknown
Enable broadcast packets rate limit, multicast packets rate limit
Bandwidth Control Configuration
Configuration Guide 453