Configuring History - TP-Link T1600G-18TS Configuration Manual

Configuring SNMP & RMON
Step 5
The following example shows how to create two statistics entries on the switch to monitor
port 1/0/1 and 1/0/2 respectively. The owner of the entry is monitor and the entry is valid:
Switch#configure
Switch(config)#rmon statistics 1 interface gigabitEthernet 1/0/1 owner monitor status
valid
Switch(config)#rmon statistics 2 interface gigabitEthernet 1/0/2 owner monitor status
valid
Switch(config)#show rmon statistics
Index Port
----- ----
1 Gi1/0/1 monitor
2 Gi1/0/2 monitor
Switch(config)#end
Switch#copy running-config startup-config

5.2.2 Configuring History

Step 1
Step 2
copy running-config startup-config
Save the settings in the configuration file.
Owner State
----- -----
valid
valid
configure
Enter global configuration mode.
rmon history index interface { fastEthernet port | gigabitEthernet port | ten-
gigabitEthernet port } [ interval seconds ] [ owner owner-name ] [ buckets number ]
Configuring RMON history entries.
Enter the index of the history entry from 1 to 12 in the format of 1-3 or 5.
index:
Enter the port number in 1/0/1 format to bind it to the entry.
port:
Set the sample interval. The values are from 10 to 3600 seconds; the default is
seconds:
1800 seconds.
Enter the owner name of the entry with 1 to 16 characters. The default name is
owner-name:
monitor.
Set the maximum number of records for the history entry. When the number of
number:
records exceeds the limit, the earliest record will be overwritten. The values are from 10 to
130; the default is 50.
RMON Configurations
Configuration Guide 725