TP-Link T1600G-18TS Configuration Manual page 656

Configuring LLDP
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
The following example shows how to configure the following parameters, lldp timer=4,
tx-interval=30 seconds, tx-delay=2 seconds, reinit-delay=3 seconds, notify-iInterval=5
seconds, fast-count=3.
Switch#configure
Switch(config)#lldp
Switch(config)#lldp hold-multiplier 4
Switch(config)#lldp timer tx-interval 30 tx-delay 2 reinit-delay 3 notify-interval 5 fast-
count 3
Switch(config)#show lldp
LLDP Status: Enabled
lldp forward_message
(Optional) Enable the switch to forward LLDP messages when LLDP function is disabled.
lldp hold-multiplier
(Optional) Specify the amount of time the neighbor device should hold the received
information before discarding it. The default is 4.
TTL (Time to Live) = Hold Multiplier * Transmit Interval.
lldp timer { tx-interval tx-interval | tx-delay tx-delay | reinit-delay reinit-delay | notify-
interval notify-interval | fast-count fast-count }
(Optional) Configure the timers for LLDP packet forwarding.
Enter the interval between successive LLDP packets that are periodically sent
tx-interval:
from the local device to its neighbors.
Specify the amount of time that the local device waits before sending another
tx-delay:
LLDP packet to its neighbors. The default is 2 seconds.
Specify the amount of time that the local device waits before sending another
reinit-delay:
LLDP packet to its neighbors. The default is 2 seconds.
Enter the interval between successive Trap messages that are periodically
notify-interval:
sent from the local device to the NMS. The default is 5 seconds.
Specify the number of packets that the local port sends when its Admin Status
fast-count:
changes. The default is 3.
show lldp
Display the LLDP information.
end
Return to Privileged EXEC Mode.
copy running-config startup-config
Save the settings in the configuration file.
LLDP Configurations
Configuration Guide 633