Voice Vlan Configuration - TP-Link T1600G-18TS Configuration Manual

Configuring Voice VLAN
2

Voice VLAN Configuration

To complete the Voice VLAN configuration, follow these steps:
1) Create a VLAN.
2) Configure OUI addresses.
3) Configure Voice VLAN globally.
4) Configure Voice VLAN mode on ports.
Configuration Guidelines
 Before configuring voice VLAN, you need to create a VLAN for voice traffic. For details
about VLAN Configuration, please refer to
 VLAN 1 is a default VLAN and cannot be configured as the voice VLAN.
 Only one VLAN can be set as the voice VLAN on the switch.
 To apply the voice VLAN configuration, you may need to further configure PVID
(Port VLAN ID) and the link type of the port which is connected to voice devices. We
recommend that you choose the mode according to your needs and configure the port
as the following table shows.
Table 2-1
Traffic on One
Port
Voice traffic
and data traffic
Voice traffic
only
Because the voice VLAN in automatic mode supports only tagged voice traffic, you
need to make sure traffic from the voice device is tagged. To do so, there are mainly
two ways:
» You can configure the voice device to forward traffic with a voice VLAN tag.
» If your switch provides the LLDP-MED feature, you can also configure it to
instruct the voice device to send tagged voice traffic. For details about LLDP-
MED, please refer to
Voice VLAN mode and Link Type of the Port
Voice Traffic Type
Tagged voice traffic
Untagged voice traffic
Tagged voice traffic
Untagged voice traffic
Configuring LLDP
Configuring 802.1Q
Suggested
Suggested Link Type and PVID
Mode
PVID cannot be the voice VLAN ID.
Automatic
Not supported.
Tagged; PVID configuration is not
required.
Manual
Untagged; PVID should be the voice
VLAN ID.
.
Voice VLAN Configuration
VLAN.
Configuration Guide 464