Ipv4 Static Route Configuration Example; Network Requirements; Configuration Considerations; Configuration Procedure - HP 1920 Gigabit Ethernet Switch Series User Manual

IPv4 static route configuration example

Network requirements

As shown in
hosts to communicate with each other.
Figure 258 Network diagram

Configuration considerations

On Switch A, configure a default route with Switch B as the next hop.
On Switch B, configure one static route with Switch A as the next hop and the other with Switch C as the
next hop.
On Switch C, configure a default route with Switch B as the next hop.

Configuration procedure

1. Configure a default route to Switch B on Switch A:
a. Select Network > IPv4 Routing from the navigation tree of Switch A.
b. Click the Create tab.
c. Enter 0.0.0.0 for Destination IP Address, 0 for Mask, and 1.1.4.2 for Next Hop.
d. Click Apply.
Figure 258, configure IPv4 static routes on Switch A, Switch B, and Switch C for any two
283