Connecting A Hunter Remote (Not Included) - Hunter ICC2 Owner's Manual

Installation Instructions
CONNECTING A HUNTER REMOTE
(NOT INCLUDED)
The ICC2 Controller is compatible with both Hunter ROAM
and ROAM XL Remotes, and each controller comes with a
factory-installed SmartPort Wiring Harness. This provides
instant remote connection capability, which enables manual
operation of your system without having to walk back and
forth from the controller.
1. To connect either a ROAM or ROAM XL Remote Kit to
your controller, simply remove the weather-resistant
rubber cover on the SmartPort, align the remote
receiver's pins with the connector, and push firmly until
the receiver is fully seated.
2.
Each ROAM and ROAM XL System is preaddressed to
work right out of the box. Once you install the receiver
into the SmartPort Wiring Harness, it will beep four
times. After approximately seven seconds, the receiver
will again beep twice to confirm that it's programmed to
the correct address. To verify that the transmitter and
receiver are communicating properly, press either the ►
or stop button on the transmitter. The receiver should
beep twice, indicating proper communication.
SCAN
for help
hunter.help/Roam
22
hunter.help/ICC2EM