Grounding; Pitot Tube; Windshield And Windows; Preparation For Service - Beechcraft Baron G58 Pilot Operating Handbook

Section 8
Handling, Serv & Maint

GROUNDING

Static ground airplane securely and effectively.

PITOT TUBE

Install cover.

WINDSHIELD AND WINDOWS

Close all windows and window vents. It is recommended that
covers be installed over windshield and windows.

PREPARATION FOR SERVICE

Remove all covers and tape, clean the airplane and give it a
thorough inspection, particularly landing gear, wheel wells,
flaps, control surfaces, and all openings.
Preflight the airplane.

EXTERNAL POWER

An external power receptacle is located on the outboard side
of the left nacelle and accepts a standard AN-type plug. The
airplane has a negative ground system. Exercise care when
utilizing any external power source to avoid reversed polarity.
An external power unit (APU) should be capable of delivering
at least 300 amperes for starting. Serviceable batteries must
be installed in the airplane. Starting with external power when
the battery is dead is not recommended. The battery manufac-
turer warns against this, also, the battery will not recharge suf-
ficiently for use if an emergency arises.
Before connecting any external power source, turn the Battery
switch ON, and all Avionic/Electrical switches OFF to avoid
damage due to electrical surges. If the external power source
does not have a standard AN-type plug, check for polarity
(negative ground) and connect the positive lead from the exter-
nal power source to the center and aft external power recepta-
cle posts. Connect the negative lead to the most forward
external power receptacle post.
8-14
Model G58
April, 2008