Other Procedures - Beechcraft Baron G58 Pilot Operating Handbook

OTHER PROCEDURES

ADS-B OUT
The installed ADS-B OUT system has been shown to meet the equipment
performance requirements of 14 CFR 91.227.
The ADS-B OUT system should be operational during all phases of flight,
including airport surface movement operations.
The ADS-B OUT system is operational when the transponder is in the ON or
ALT mode. This will be indicated in the transponder window in the lower right
corner of the PFD.
If the G1000 NXi system is unable to transmit ADS-B OUT messages, the
following message will post on the PFD in the alerts window:
XPDR1 ADS-B NO POS – Transponder: ADS-B is not transmitting position.
If the above message is received, verify valid GPS position is available.
1. MFD AUX – GPS Status Page ........................... VERIFY GPS Position
PRESSURE ALTITUDE BROADCAST INHIBIT
While conducting operations within airspace that requires ADS-B Out
transmissions, operate the transponder in ALT mode unless requested
otherwise by ATC. If ATC requests the inhibit of pressure altitude
transmissions, select the transponder to ON mode:
1. XPDR Softkey on PFD .............................................................. PRESS
2. ON Softkey ............................................................................... PRESS
Textron Aviation G36 Bonanza and G58 Baron with G1000 NXi
Page 24 of 24
190-02128-03 Rev. 1
FAA APPROVED