Beechcraft Baron G58 Pilot Operating Handbook page 202

Section 4
Normal Procedures
Use of Roll Mode [ROL]
1. AP Key . . . . . PRESS TO ENGAGE AUTOPILOT & YD
green [ROL], [AP], [YD], [PIT], & white [ALT] Displayed
If bank angle is  6°:
2. Bank Angle is Maintained
If bank angle is < 6°:
3. Existing heading is maintained
To Change Bank Angle or Heading:
4. CWS Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . PRESS
5. Heading or Bank Angle . . . . . . . CHANGE AS DESIRED
6. CWS Switch . . . . . . . . . . . . . . . . . . . . . . . . . . RELEASE
Use of Heading Hold Mode [HDG]
1. Heading Knob . . . . . . . . . . . . SET DESIRED HEADING
a. Press knob to select existing heading.
b. Rotate knob to select a new heading.
c. New heading will be displayed in box to left of HSI for
3 seconds.
2. HDG Key . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PRESS
3. The airplane will turn in the direction the HDG bug is
moved unless the heading change is greater than 340°.
Use of Navigation Mode [GPS], [VOR], [LOC], or [BC]
If not initially established on the desired course:
1. CDI Key . . . . . . . . . . . SELECT NAVIGATION SOURCE
2. CRS Knob (if required) . . . . . . SET DESIRED COURSE
(course will be displayed in the box to right of HSI for 3
seconds)
3. HDG Knob . . . . . . . . . .SELECT INTERCEPT HEADING
4-34
Model G58
[HDG] Displayed
June, 2011