Beechcraft Baron G58 Pilot Operating Handbook page 321

Section 7
Model G58 Systems Description
Seat Backs - Use the release lever located at the aft inboard
side of each seat to vary the inclination of the seat back to one
of four preset positions. Lean forward to release pressure on
the seat back. Lift the lever up, and then allow the seat back to
recline to the desired position. (The seat backs of the middle
two seats may have to be folded aft to reach the full aft posi-
tion.)
The middle two seats are adjustable as follows:
Forward and Aft - Pull up on the release bar located below the
forward right side of the seat and slide the seat to the desired
position.
Seat Backs - The seat backs are equipped with a locking back
to accommodate the shoulder harness. Thus, the seat backs
cannot be reclined, but can be folded down by releasing the
handle located on the aft inboard side of each seat.
The Aft two seats are adjustable as follows:
The seat backs can be folded down to provide access to the
extended baggage compartment. The seat cushions can be
folded up to provide additional floor space.
Outboard armrests for all seats are built into the cabin side-
walls. Center armrests of the front two seat and the middle two
seats can be elevated or positioned flush with the seat cush-
ions. Lift up on the arm rest and raise to the elevated position.
It will automatically lock into place. To lower the arm rests, lift
up and move it forward.
When the club seating arrangement is utilized, the aft-facing
seats must have the headrests in the fully raised position dur-
ing takeoff and landing.
If desired, the 3rd and 4th seats can be arranged to face for-
ward in the cabin. These movable stops are located on the
tracks under each seat. The stops should be located as fol-
lows:
7-21
May, 2015