Lifestand LSCT Service Manual page 75

LSCT
Item N° 326617
CHAIR WIRING (2/5):
View of backrest from behind
Backrest
actuator
View from behind in
standing position
Leave some slack
because the distance
between the backrest
cross beam and the
upper seat tube
increases in sit position
(Check the slack if you
change the seat depth).
The chair must be fully
in standing position
when tightening this
collar because it is at
that time that it requires
the greatest length.
Maintenance manual
Revision A Date 25/06/2015
Bundles:
- Angle sensor
- Backrest actuator
- R-NET control
Page 75 of 93
Leave some slack
to be able to lift up
the armrest
Leave some slack to be able
to fold back the backrest.
(Check the slack if you
change the seat width).
Backrest cross beam
Bundles:
- Angle sensor
- Backrest actuator
- R-NET control
Upper seat tube
WIRING: