Backrest Actuator (1/2) - Lifestand LSCT Service Manual

LSCT
Item N° 326617

BACKREST ACTUATOR (1/2):

Dismantling:
1. Place the chair in standing position.
2. Remove the back cover (See section
«Back cover»).
3. Cut the clamping collars which hold the
cable from the actuator up to the ISM.
(Note the location of the clamping collars
so that the actuator can be rewired).
4. Place the chair in the sitting position. (Be
careful not to cut the cables which have
been detached when moving from the
standing position to the sitting position).
5. Remove the two pins «a» (See figure 60).
6. Remove the axles which held the pins.
(hold the armrests so that they do not
fall). (See figure 60)
7. Remove the half-moon pin «b». (See
figure 60)
8. Fold down the backrest.
9. Undo the top fastening of the backrest
actuator. (See figure 61)
10. Remove the backrest actuator.
WARNING !
When handling the hinged components
be careful not to pinch your fingers.
Maintenance manual
Revision A Date 25/06/2015 Page 26 of 93
a
a
b
Figure 60
Figure 61
REPAIRS: