Standing Actuator (1/2); Standing Actuator (2/2) - Lifestand LSCT Service Manual

LSCT
Item N° 326617

STANDING ACTUATOR (1/2):

Dismantling:
1. Place the chair in standing position.
2. Remove the back cover (See section
«Back cover»).
3. Cut the clamping collars which hold the
cable from the actuator up to the ISM. Do
not disconnect the actuator. (Note the
location of the clamping collars so that the
new actuator can be rewired.).
4. Place the chair in the sitting position.
5. Disconnect the jack plug of the standing
actuator.
6. Remove the seat cushion.
7. Undo the 4 screws holding the front seat
plate. (See figure 64)
8. Remove the front seat plate.
9. Undo the 2 screws above the standing
actuator (Only one of the two screws will
unscrew). (See figure 65)
10. Remove the axle. (Hold the actuator so
that it doesn't fall). (See figure 65)
11. Unscrew the lower actuator fastening.
(See figure 66)
12. Remove the standing actuator.
Maintenance manual
Revision A Date 25/06/2015 Page 28 of 93
REPAIRS:
Figure 64
Figure 65
Figure 66