Lifestand LSCT Service Manual page 71

LSCT
Item N° 326617
STRAP TENSION LEGREST COMPENSATION :
1. Tilt the seat and pull out the legrest.
2. Loosen the two screws of the strap
retaining plate (See figure 163-a for the
big compensations (16 and 20cm) (and
figure 163-b for the small compensations
(8 and 10 cm).
3. Tighten the strap (push the strap through
the slot of the plate and pull the strap to
successfully tender).
4. Pull in the legrest up to the position
shown on figure 173.
5. Pull out the legrest and re-tighten the
strap retaining plate.
6. Pull in the legrest and check that the
sensor is well activated. (If this is not the
case, slightly loosen the strap and try
again).
7. For small compensations (8 and 10cm),
wrap the excess strap, attach it with a
cable tie (See figure 174-a) and place it in
the legrest guiding rail (See figure 174-b).
Maintenance manual
Revision A Date 25/06/2015 Page 71 of 93
Figure 171
Figure 172
Calf pad
bracket
Alignment
Connecting
rod « A »
Figure 173
Figure 174-a
SETTINGS :
Figure 174-b