Lifestand LSCT Service Manual page 68

LSCT
Item N° 326617
LEGREST COMPENSATION ADJUSTMENT (1/3) :
1. There are four compensation settings:
Small compensations
Big compensations
2. Tilt the seat and pull out the legrest.
3. Loosen the two screws of the strap
retaining plate (See figure 163-a for the
big compensations and figure 163-b for
the small compensations.
4. If you will change a big compensation for
a small one or the reverse, unmounts the
other strap retaining plate.
5. For compensations 10cm and 20cm ;
position the actuator ring in the low
position.
For compensations 8cm and 16cm,
position the actuator ring in the high
position. (on figure 164-a and 164-b, the
ring is shown in the low position)
6. Unscrew the four countersunk head
screws as well as the two cylinder head
screws. (See figure 164-a & 164-b)
7. Slide the ring into the desired position.
(See figure 165) Put a screwdriver in the
slot of the ring and turn it to spread the
ring and facilitate its translation (If
necessary tap gently on the ring with a
mallet).
8. If you will change a big compensation for
a small one or the reverse, completely
remove the strap. Otherwise, proceed to
the next step.
Maintenance manual
Revision A Date 25/06/2015
8 et 10cm
16 et 20cm
Figure 163-a
Figure 164-a
Figure 164-b
Left side view
Figure 165
Page 68 of 93
SETTINGS:
Figure 163-b
Left side view
Right side view