Lifestand LSCT Service Manual page 12

LSCT
Item N° 326617
BATTERIES (2/2):
Assembly:
Assemble in the reverse order.
1. Insert the front battery ensuring that
the connector guards are in the right
position. (Warning, the battery
connectors must under no
circumstances come into contact with
any other components).
2. Reconnect the wire bundles to the
front battery and tightening the
screws (Be careful to the orientation
of the connector (see Figure 22 and
23-b)) (Tightening torque: 11.1N.m).
(See section «Electrical circuit
diagram»).
3. Insert the second battery and
reconnect the wire bundles to the
rear battery and tighten the screws
(Be careful to the orientation of the
connector (see Figure 23 and 23-b))
(Tightening torque: 11.1N.m). (See
section «Electrical circuit diagram»)
4. Put back the closing plate (See step
2 and 3 section «ISM and/or Power
Module»).
5. Put back the underride guard (See
section «Underride guard and
antitipper wheels»).
6. Plug back the motors and power
cables on the power module (See
section «Electrical circuit diagram»)
7. Put back the fuse (See section
«Fuse»)
8. Put back the back cover (See section
«Back cover»).
WARNING !
Be careful when using metal tools or
objects close to the batteries, a short-
circuit can easily cause an explosion.
Always use gloves and safety
glasses.Remember that the batteries
are heavy and they must be handled
extremely carefully.
Maintenance manual
Revision A Date 25/06/2015 Page 12 of 93
Connector
guards
Figure 22
Figure 23-a
Figure 23-b
REPAIRS: