Seat Depth Adjustment (1/2); Settings - Lifestand LSCT Service Manual

LSCT
Item N° 326617

SEAT DEPTH ADJUSTMENT (1/2):

Dismantling:
1. Place the chair in a slightly standing
position (take out the standing actuator by
about 50mm).
2. Remove the seat cushion
3. Remove the two screws holding the front
and rear seat plates together. (See figure
133)
4. Remove the 4 screws located on the
upper seat then the 2 screws located on
the lower seat (from each side). (See
figure 134)
5. Adjust the seat to the desired depth. (if
necessary modify the wiring (see section
«Chair wiring»)). (See figure 135)
Maintenance manual
Revision A Date 25/06/2015 Page 56 of 93

SETTINGS:

Figure 133
Figure 134
Figure 135