Rear Wheels (1/2) - Lifestand LSCT Service Manual

LSCT
Item N° 326617

REAR WHEELS (1/2):

Dismantling:
1. Place the chair on wedges so that the
rear wheels are no longer in contact with
the ground. (Leave the motor in the
«ENGAGED» position).
2. Remove the plastic cover using a flat-
head screwdriver (be careful not to
damage the rim). (See figure 24).
3. Remove the 4 cylindrical head screws.
(See figure 25).
4. Remove the wheel.
5. To change the tyre, inner tube or the solid
tyre, remove the 5 screws (inside edge of
the wheel) and separate the interior
section from the outer section of the rim.
(See figure 27).
WARNING !
The tyre pressure recommended for the rear
tyres is between 2.5 and 3 bar. Over-inflation
can cause the tyre to explode. Under-
inflation will lead to stability and handling
problems, as well as premature wear and
tear. It is important to check the tyre pressure
regularly.
Maintenance manual
Revision A Date 25/06/2015 Page 13 of 93
Figure 24
Figure 25
Figure 26
REPAIRS:
Figure 27