Seat Tilt; Guide Rails - Lifestand LSCT Service Manual

LSCT
Item N° 326617

SEAT TILT:

GUIDE RAILS

Dismantling:
WARNING !
There must be no load on the wheelchair
1. Place the chair in standing position.
2. Take off the back cover (See section
«Back cover»).
3. Remove the 4 screws on the «trolley».
(See figure 46)
4. Place the trolley carefully on the batteries.
5. Remove the 5 screws fixed to the rail.
(move the rail pad to gain access to all
the screws). (See figure 47)
WARNING !
When removing the rails, hold the seat of the
chair to stop it tipping over.
6. Replace the rail.
Assembly:
Assemble in the reverse order.
1. Attach the rail by tightening the 5
countersunk head screws (Tightening
torque: 11.1N.m). (Move the pad to gain
access to all the screws). (See figure 48)
2. Reattach the trolley by tightening the 4
cylindrical head screws on the rail pads.
(Tightening torque: 9.8N.m). (See figure
49)
3. Replace the back cover (See section
«Back cover»).
Maintenance manual
Revision A Date 25/06/2015
«Trolley»
Figure 46
Pad
Figure 47
Pad
Figure 48
Figure 49
Page 21 of 93
REPAIRS: