Backrest Actuator (2/2) - Lifestand LSCT Service Manual

LSCT
Item N° 326617

BACKREST ACTUATOR (2/2):

Assembly:
Assemble in the reverse order.
1. Insert the new backrest actuator.
2. Insert the higher fastening axle of the
backrest actuator and tighten the nut.
(See figure 62)
3. Straighten the backrest.
4. Insert the half-moon pin «b» through the
shaft of the actuator and the lower cross
beam of the backrest. (See figure 63)
5. Insert the axles or the armrest through the
armrest pads and the indexing ties. (See
figure 63)
6. Insert the pins «a». (See figure 63)
7. Place the chair in standing position.
8. Rewire the backrest actuator (See
sections «Electrical circuit diagram» and
«Chair wiring») and replace the clamping
collars.
9. Put back the back cover (See section
«Back cover»).
WARNING !
When handling the hinged components
be careful not to pinch your fingers.
Maintenance manual
Revision A Date 25/06/2015 Page 27 of 93
Figure 62
a
b
Figure 63
REPAIRS:
a