Seat Plates - Lifestand LSCT Service Manual

LSCT
Item N° 326617

SEAT PLATES:

Dismantling:
1. Remove the seat cushion.
2. Remove the Velcro strips on the seat
plates. (Place the Velcro strips on the
non-stick side so that they can be re-
stuck onto the new seat plates.)
3. Remove the 6 screws which hold the seat
plates. (Be careful not to lose the spacers
located at the rear holes under the rear
seat plate) (See figure 119)
4. Remove the seat plates.
Assembly:
Assemble in the reverse order.
1. Place the new seat plates into position.
2. Attach the seat plates with the 6 screws
((Tightening torque: 11.1N.m) (Don't
forget to place the spacers located at the
two rear screws)). (See figure 120)
3. If possible, re-stick the Velcro strips from
the old seat plates, if not stick new ones.
4. Replace the seat cushion.
WARNING !
Make sure to place well the front the seat
plate (See figure 121).
Maintenance manual
Revision A Date 25/06/2015
Spacer
Figure 119
Spacer
Figure 120
60
Figure 121
Page 48 of 93
REPAIRS: