Legrest Lower Bearing - Lifestand LSCT Service Manual

LSCT
Item N° 326617

LEGREST LOWER BEARING:

Dismantling:
1. Remove the sliding part (See section
«Legrest guide rail» up to stage 4).
2. Remove the 4 countersunk head
screws. (See figure 96)
WARNING !
When removing the last screw, hold the
actuator so that it doesn't fall.
3. Remove the bearing and its axle using
multi-grips pliers holding the external
ring. (See figure 97)
Assembly:
Assemble in the reverse order.
1. Position the new axle+bearing set. (Use
a drift punch and a mallet to hit the
bearing axle) (See figure 98)
WARNING !
Do not hit the external ring of the bearing.
2. Re-tighten the 4 countersunk head
screws. (See figure 99)
3. Replace the sliding part of the legrest
(See section «Legrest guide rail» as of
step 3).
Maintenance manual
Revision A Date 25/06/2015 Page 37 of 93
REPAIRS:
Figure 96
Figure 97
Figure 98
Figure 99