Motors (1/2) - Lifestand LSCT Service Manual

LSCT
Item N° 326617

MOTORS (1/2):

1. Place the chair on a wedge (the rear
wheels must not be in contact with the
ground).
2. Place the chair in standing position.
3. Take off the back cover (See section
«Back cover»).
4. Cut the clamping collars which hold the
motor cable. (Note the location of the
clamping collars so that you can
reconnect the motor cable.)
5. Disconnect the motor cable from the
Power Module.
6. Take off the rear wheel (See section
«Rear wheel»).
7. Remove the motor from its support by
removing the 4 screws. (See figure 107)
Maintenance manual
Revision A Date 25/06/2015 Page 42 of 93
REPAIRS:
Figure107
: