HP MSR2000 series Configuration Manual page 442

Figure 132 Network diagram
VPN 1
2012:1::/64
2012:1::2/64
Configuration procedure
Assume that the system name of the IPv6 MCE device is MCE, the system names of the edge devices of
VPN 1 and VPN 2 are VR1 and VR2, respectively, and the system name of PE 1 is PE1.
Configure the VPN instances on the MCE and PE 1.
1.
# On the MCE, configure VPN instances vpn1 and vpn2, and specify a RD and route targets for
each VPN instance.
<MCE> system-view
[MCE] ip vpn-instance vpn1
[MCE-vpn-instance-vpn1] route-distinguisher 10:1
[MCE-vpn-instance-vpn1] vpn-target 10:1
[MCE-vpn-instance-vpn1] quit
[MCE] ip vpn-instance vpn2
[MCE-vpn-instance-vpn2] route-distinguisher 20:1
[MCE-vpn-instance-vpn2] vpn-target 20:1
[MCE-vpn-instance-vpn2] quit
# Create VLAN 10, add port GigabitEthernet 1/0/1 to VLAN 10, and create VLAN-interface 10.
[MCE] vlan 10
[MCE-vlan10] port gigabitethernet 1/0/1
Vlan-int10
2001:1::2/64
GE1/0/1
Vlan-int11
Vlan-int10
VR 1
2001:1::1/64
Vlan-int20
2002:1::2/64
GE1/0/1
Vlan-int30: 30::2/64
Vlan-int40: 40::2/64
MCE
GE1/0/3
Vlan-int30: 30::1/64
Vlan-int40: 40::1/64
GE1/0/2
Vlan-int20
2002:1::1/64
VR 2
Vlan-int21
2012::2/64
VPN 2
2012::/64
429
PE 2
PE 1
PE 3
VPN 2
Site 1
CE
CE
VPN 1
Site 2