HP MSR2000 series Configuration Manual page 365

[SwitchB-bgp-af-ipv6] peer 1::1 ipsec-policy policy001
[SwitchB-bgp-af-ipv6] quit
[SwitchB-bgp] quit
Apply IPsec policies to EBGP peers:
6.
# Configure Switch C.
[SwitchC] bgp 65009
[SwitchC-bgp] ipv6-family
[SwitchC-bgp-af-ipv6] peer ebgp ipsec-policy policy002
[SwitchC-bgp-af-ipv6] quit
[SwitchC-bgp] quit
# Configure Switch B.
[SwitchB] bgp 65008
[SwitchB-bgp] ipv6-family
[SwitchB-bgp-af-ipv6] peer ebgp ipsec-policy policy002
[SwitchB-bgp-af-ipv6] quit
[SwitchB-bgp] quit
Verify the configuration:
7.
# Display detailed IPv6 BGP peer information.
[SwitchB] display bgp ipv6 peer verbose
BGP Peer is 1::1,
Type: IBGP link
BGP version 4, remote router ID 1.1.1.1
BGP current state: Established, Up for 00h01m51s
BGP current event: RecvKeepalive
BGP last state: OpenConfirm
Port:
Configured: Active
Received
Negotiated: Active
Peer optional capabilities:
Peer support bgp multi-protocol extended
Peer support bgp route refresh capability
Address family IPv4 Unicast: advertised and received
Received: Total 0 messages, Update messages 0
Sent: Total 0 messages, Update messages 0
Maximum allowed prefix number: 4294967295
Threshold: 75%
Minimum time between advertisement runs is 30 seconds
Optional capabilities:
Route refresh capability has been enabled
ORF advertise capability based on prefix (type 64):
Local: both
Negotiated: send
Peer Preferred Value: 0
IPsec policy name: policy001, SPI :12345
remote AS 65008,
Local – 1029 Remote - 179
Hold Time: 180 sec
: Active Hold Time: 180 sec
Hold Time: 180 sec
352
Keepalive Time: 60 sec