HP MSR2000 series Configuration Manual page 368

Hide thumbs Also See for MSR2000 series:
Table of Contents

Advertisement

[SwitchA] route-policy apply_med_50 permit node 10
[SwitchA-route-policy] if-match ipv6 address acl 2000
[SwitchA-route-policy] apply cost 50
[SwitchA-route-policy] quit
[SwitchA] route-policy apply_med_100 permit node 10
[SwitchA-route-policy] if-match ipv6 address acl 2000
[SwitchA-route-policy] apply cost 100
[SwitchA-route-policy] quit
Apply routing policy apply_med_50 to routes outgoing to peer 3001::3, and apply routing
policy apply_med_100 to routes outgoing to peer 2001::3.
[SwitchA] bgp 200
[SwitchA-bgp] ipv6-family
[SwitchA-bgp-af-ipv6] network 1200:: 64
[SwitchA-bgp-af-ipv6] peer 3001::3 route-policy apply_med_50 export
[SwitchA-bgp-af-ipv6] peer 2001::3 route-policy apply_med_100 export
# Configure BFD over the link to peer 3001::3 so that when the link Switch A<—>Switch
B<—>Switch C fails, BFD can quickly detect the failure and notify it to IPv6 BGP, and then the link
Switch A<—>Switch D<—>Switch C takes effect immediately.
[SwitchA-bgp-af-ipv6] peer 3001::3 bfd
[SwitchA-bgp-af-ipv6] quit
[SwitchA-bgp] quit
Configure IPv6 BGP on Switch C:
4.
<SwitchC> system-view
[SwitchC] bgp 200
[SwitchC-bgp] ipv6-family
[SwitchC-bgp-af-ipv6] peer 3000::1 as-number 200
[SwitchC-bgp-af-ipv6] peer 3000::1 bfd
[SwitchC-bgp-af-ipv6] peer 2000::1 as-number 200
[SwitchC-bgp-af-ipv6] quit
[SwitchC-bgp] quit
Configure BFD parameters (you can use default BFD parameters instead):
5.
# Configure Switch A.
[SwitchA] bfd session init-mode active
[SwitchA] interface vlan-interface 100
Configure the minimum interval for transmitting BFD control packets as 500 milliseconds.
[SwitchA-Vlan-interface100] bfd min-transmit-interval 500
Configure the minimum interval for receiving BFD control packets as 500 milliseconds.
[SwitchA-Vlan-interface100] bfd min-receive-interval 500
Configure the detect multiplier as 7.
[SwitchA-Vlan-interface100] bfd detect-multiplier 7
[SwitchA-Vlan-interface100] quit
# Configure Switch C.
[SwitchC] bfd session init-mode active
[SwitchC] interface vlan-interface 101
355

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Msr3000 seriesMsr4000 series

Table of Contents