HP MSR2000 series Configuration Manual page 428

Figure 131 Network diagram
Configuration procedure
Configure VPN instances:
1.
# Create VPN instances on the MCE and PE 1, and bind the VPN instances with VLAN interfaces.
For the configuration procedure, see
Configure routing between the MCE and VPN sites:
2.
# Start an OSPF process on the devices in the two VPNs and advertise the subnets. (Details not
shown.)
# Configure OSPF on the MCE, and bind OSPF process 10 with VPN instance vpn1 to learn the
routes of VPN 1.
<MCE> system-view
[MCE] ospf router-id 10.214.10.3 10 vpn-instance vpn1
[MCE-ospf-10] area 0
[MCE-ospf-10-area-0.0.0.0] network 10.214.10.0 0.0.0.255
# Display the routing table of VPN 1 on the MCE.
[MCE-ospf-10-area-0.0.0.0] display ip routing-table vpn-instance vpn1
Routing Tables: vpn1
Destination/Mask
10.214.10.0/24
10.214.10.3/32
127.0.0.0/8
Destinations : 5
Proto Pre
Direct 0
Direct 0
Direct 0
"Using OSPF to advertise VPN routes to the
Routes : 5
Cost NextHop
0 10.214.10.3
0 127.0.0.1
0 127.0.0.1
415
PE."
Interface
Vlan10
InLoop0
InLoop0