Configuring The P2P Network Type For An Interface; Configuring Ospf Route Control; Configuration Prerequisites - HP MSR2000 series Configuration Manual

Step
2. Enter interface view.
3. Configure the OSPF network
type for the interface as
P2MP.
4. Exit to system view.
5. Enter OSPF view.
6. Specify a neighbor and its
router priority on a P2MP
unicast network.

Configuring the P2P network type for an interface

Step
1. Enter system view.
2. Enter interface view.
3. Configure the OSPF network
type for the interface as P2P.

Configuring OSPF route control

This section describes how to control the advertisement and reception of OSPF routing information, as
well as route redistribution from other protocols.

Configuration prerequisites

Before you configure OSPF route control, complete the following tasks:
Configure IP addresses for interfaces.
•
Configure OSPF basic functions.
•
• Configure filters if routing information filtering is needed.
Command
interface interface-type
interface-number
ospf network-type p2mp [ unicast ]
quit
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
peer ip-address [ cost value |
dr-priority dr-priority ]
Command
system-view
interface interface-type
interface-number
ospf network-type p2p
78
Remarks
N/A
By default, the network type of an
interface depends on the link layer
protocol.
After you configure the OSPF
network type for an interface as
P2MP unicast, all packets are unicast
over the interface. The interface
cannot broadcast hello packets to
discover neighbors. In that case, you
need to manually specify the
neighbors.
N/A
N/A
Required if the interface type is
P2MP unicast.
Remarks
N/A
N/A
By default, the network type of an
interface depends on the link layer
protocol.