Configuring Ripng Route Redistribution - HP MSR2000 series Configuration Manual

# Configure Switch B to filter incoming and outgoing route.
[SwitchB] acl ipv6 number 2000
[SwitchB-acl6-basic-2000] rule deny source 3::/64
[SwitchB-acl6-basic-2000] rule permit
[SwitchB-acl6-basic-2000] quit
[SwitchB] ripng 1
[SwitchB-ripng-1] filter-policy 2000 import
[SwitchB-ripng-1] filter-policy 2000 export
# Display routing tables of Switch B and Switch A.
[SwitchB] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::20F:E2FF:FE23:82F5
Dest 1::/64,
via FE80::20F:E2FF:FE23:82F5, cost
Dest 2::/64,
via FE80::20F:E2FF:FE23:82F5, cost
Peer FE80::20F:E2FF:FE00:100
Dest 4::/64,
via FE80::20F:E2FF:FE00:100, cost
Dest 5::/64,
via FE80::20F:E2FF:FE00:100, cost
[SwitchA] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::20F:E2FF:FE00:1235
Dest 1::/64,
via FE80::20F:E2FF:FE00:1235, cost
Dest 4::/64,
via FE80::20F:E2FF:FE00:1235, cost
Dest 5::/64,
via FE80::20F:E2FF:FE00:1235, cost

Configuring RIPng route redistribution

Network requirements
Two RIPng processes are running on Switch B, which communicates with Switch A through RIPng 100
and with Switch C through RIPng 200.
Configure route redistribution on Switch B, letting the two RIPng processes redistribute routes from each
other. Set the default cost of redistributed routes from RIPng 200 to 3.
on Vlan-interface100
1, tag 0, A, 2 Sec
1, tag 0, A, 2 Sec
on Vlan-interface200
1, tag 0, A, 5 Sec
1, tag 0, A, 5 Sec
on Vlan-interface100
1, tag 0, A, 2 Sec
2, tag 0, A, 2 Sec
2, tag 0, A, 2 Sec
269