Ipv6 Vrrp Configuration Examples; Single Vrrp Group Configuration Example - HP 5900 Series Configuration Manual

The output shows that when the timeout timer expires, the VF for virtual MAC address
000f-e2ff-0011 is removed, and no longer forwards the packets destined for the MAC address.
# When Switch A fails, display detailed information about VRRP group 1 on Switch B.
[SwitchB-Vlan-interface2] display vrrp verbose
IPv4 Virtual Router Information:
Running Mode
Total number of virtual routers : 1
Interface Vlan-interface2
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Member IP List : 10.1.1.3 (Local, Master)
Forwarder Information: 2 Forwarders 1 Active
Config Weight
Running Weight : 255
Forwarder 02
State
Virtual MAC
Owner ID
Priority
Active
Forwarder 03
State
Virtual MAC
Owner ID
Priority
Active
Forwarder Weight Track Information:
Track Object
The output shows that when Switch A fails, Switch B becomes the master because it has a higher
priority than Switch C, and the VF for virtual MAC address 000f-e2ff-0011 is removed.

IPv6 VRRP configuration examples

This section provides examples of configuring IPv6 VRRP applications on switches.

Single VRRP group configuration example

This section provides an example of configuring a single VRRP group on switches.
Network requirements
Switch A and Switch B form a VRRP group, and use the virtual IP addresses 1::10/64 and FE80::10 to
provide gateway service for the subnet where Host A resides, as shown in
: Load Balance
: 1
: Up
: 110
: Yes
: None
: 10.1.1.1
10.1.1.4 (Backup)
: 255
: Active
: 000f-e2ff-0012 (Owner)
: 0000-5e01-1103
: 255
: local
: Listening
: 000f-e2ff-0013 (Learnt)
: 0000-5e01-1105
: 127
: 10.1.1.4
: 1 State : Positive
102
Adver Timer : 100
State : Master
Running Pri : 110
Delay Time : 5
Weight Reduced : 250
Figure 29.