Configuration Prerequisites; Configuring Ipv6 Bgp Timers; Configuring Ipv6 Bgp Soft Reset - HP MSR2000 series Configuration Manual

Configuration prerequisites

Before you configure IPv6 BGP timers, complete the following tasks:
Enable IPv6.
•
Configure IPv6 BGP basic functions.
•

Configuring IPv6 BGP timers

Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 address family view.
4. Configure IPv6 BGP timers.
5. Configure the interval for
sending the same update to an
IPv6 peer or peer group.

Configuring IPv6 BGP soft reset

Enabling route refresh
Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 address
family view.
4. Enable route refresh.
Performing manual soft-reset
Command
system-view
bgp as-number
ipv6-family
•
Specify keepalive interval and
holdtime:
timer keepalive keepalive hold
holdtime
•
Configure keepalive interval
and holdtime for an IPv6 peer
or peer group:
peer { ipv6-group-name
|.ipv6-address } timer
keepalive keepalive hold
holdtime
peer { ipv6-group-name |
ipv6-address }
route-update-interval interval
Command
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name | ipv6-address }
capability-advertise route-refresh
335
Remarks
N/A
N/A
N/A
Optional.
The keepalive interval defaults to
60 seconds, holdtime defaults to
180 seconds.
The holdtime interval must be at
least three times the keepalive
interval.
Timers configured by using the
timer command have lower
priority than timers configured by
using the peer timer command.
Optional.
The interval for sending the same
update to an IBGP peer or an
EBGP peer defaults to 15
seconds or 30 seconds.
Remarks
N/A
N/A
N/A
Optional.
Enabled by default.