HP MSR2000 series Configuration Manual page 25

Figure 2 Network diagram
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
Configure static routes:
2.
# Configure a default route on Switch A.
<SwitchA> system-view
[SwitchA] ip route-static 0.0.0.0 0.0.0.0 1.1.4.2
# Configure two static routes on Switch B.
<SwitchB> system-view
[SwitchB] ip route-static 1.1.2.0 255.255.255.0 1.1.4.1
[SwitchB] ip route-static 1.1.3.0 255.255.255.0 1.1.5.6
# Configure a default route on Switch C.
<SwitchC> system-view
[SwitchC] ip route-static 0.0.0.0 0.0.0.0 1.1.5.5
Configure the default gateways of hosts A, B, and C as 1.1.2.3, 1.1.6.1, and 1.1.3.1. (Details
3.
not shown.)
Verify the configuration:
4.
# Display the IP routing table on Switch A.
[SwitchA] display ip routing-table
Routing Tables: Public
Destination/Mask
0.0.0.0/0
1.1.2.0/24
1.1.2.3/32
1.1.4.0/30
1.1.4.1/32
127.0.0.0/8
127.0.0.1/32
# Display the IP routing table on Switch B.
Destinations : 7
Proto Pre
Static 60
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
Routes : 7
Cost NextHop
0 1.1.4.2
0 1.1.2.3
0 127.0.0.1
0 1.1.4.1
0 127.0.0.1
0 127.0.0.1
0 127.0.0.1
12
Interface
Vlan500
Vlan300
InLoop0
Vlan500
InLoop0
InLoop0
InLoop0