RFC 2453, RIP Version 2
•
RIP configuration task list
Task
Configuring RIP basic functions
Configuring RIP route
control
Tuning and optimizing
RIP networks
Configuring RIP FRR
Configuring BFD for RIP
Configuring RIP basic functions
Configuration prerequisites
Before you configure RIP basic functions, complete the following tasks:
Configure the link layer protocol.
•
Configure IP addresses for interfaces, and make sure that all neighboring routers can reach each
•
other.
Enabling RIP and a RIP interface
Follow these guidelines when you enable RIP:
Configuring an additional routing metric
Configuring RIPv2 route summarization
Disabling host route reception
Advertising a default route
Configuring inbound or outbound route filtering
Configuring a priority for RIP
Configuring RIP route redistribution
Configuring RIP timers
Configuring split horizon and poison reverse
Configuring the maximum number of ECMP routes
Enabling zero field check on incoming RIPv1
messages
Enabling source IP address check on incoming RIP
updates
Configuring RIPv2 message authentication
Specifying a RIP neighbor
Configuring RIP-to-MIB binding
Configuring the RIP packet sending rate
Single-hop echo detection mode
Bidirectional control detection mode
24
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional