Ipv6 Bgp Configuration Examples; Ipv6 Bgp Basic Configuration Example - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Destination: 1.1.1.1/32
Protocol: BGP
SubProtID: 0x1
Cost: 0
IpPre: N/A
Tag: 0
OrigTblID: 0x0
TableID: 0x2
NibID: 0x15000003
AttrID: 0x1
Flags: 0x10060
Label: NULL
BkLabel: NULL
Tunnel ID: Invalid
BkTunnel ID: Invalid
FtnIndex: 0x0

IPv6 BGP configuration examples

IPv6 BGP basic configuration example

Network requirements
In Figure 74, run EBGP between Switch A and Switch B, and run IBGP between Switch B and Switch C
so that Switch C can access the network 50::/64 connected to Switch A.
Figure 74 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure IBGP:
# Configure Switch B.
<SwitchB> system-view
[SwitchB] bgp 65009
[SwitchB-bgp] router-id 2.2.2.2
[SwitchB-bgp] peer 9::2 as-number 65009
[SwitchB-bgp] address-family ipv6
[SwitchB-bgp-ipv6] peer 9::2 enable
[SwitchB-bgp-ipv6] quit
# Configure Switch C.
Process ID: 0
Age: 00h00m36s
Preference: 255
QosLocalID: N/A
State: Active Adv
OrigVrf: default-vrf
OrigAs: 100
LastAs: 100
Neighbor: 2.2.2.2
OrigNextHop: 2.2.2.2
RealNextHop: 20.1.1.2
BkNextHop: 40.1.1.3
Interface: Vlan-interface 101
BkInterface: Vlan-interface 201
292