Enabling Is-Is Snmp Trap; Binding An Is-Is Process With Mibs; Configuring Bfd For Is-Is; Displaying And Maintaining Is-Is - HP MSR2000 series Configuration Manual

Enabling IS-IS SNMP trap

This task enables IS-IS to generate traps and send them to the information center of the device. The
information center determines whether to output the traps and where to output. For more information
about information center, see Network Management and Monitoring Configuration Guide.
To enable IS-IS SNMP trap:
Step
1. Enter system view.
2. Enter IS-IS view.
3. Enable SNMP trap.

Binding an IS-IS process with MIBs

This task allows you to bind MIB with an IS-IS process to send and collect information. For more
information about MIB, see Network Management and Monitoring Configuration Guide.
To bind an IS-IS process with MIBs:
Step
1. Enter system view.
2. Enter IS-IS view.
3. Bind the IS-IS process with
MIBs.

Configuring BFD for IS-IS

Step
1. Enter system view.
2. Enter interface view.
3. Enable IS-IS on the interface.
4. Enable BFD on the IS-IS
interface.

Displaying and maintaining IS-IS

Command
system-view
isis [ process-id ] [ vpn-instance vpn-instance-name ]
is-snmp-traps enable
Command
system-view
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
isis mib-binding process-id
Command
system-view
interface interface-type interface-number
isis enable [ process-id ]
isis bfd enable
159
Remarks
N/A
N/A
Enabled by default
Remarks
N/A
N/A
By default, MIBs are bound with
IS-IS process 1.
Remarks
N/A
N/A
Disabled by default.
Not enabled by default.