HP MSR2000 series Configuration Manual page 369

Configure the minimum interval for transmitting BFD control packets as 500 milliseconds.
[SwitchC-Vlan-interface101] bfd min-transmit-interval 500
Configure the minimum interval for receiving BFD control packets as 500 milliseconds.
[SwitchC-Vlan-interface101] bfd min-receive-interval 500
Configure the detect multiplier as 7.
[SwitchC-Vlan-interface101] bfd detect-multiplier 7
[SwitchC-Vlan-interface101] return
Verify the configuration:
6.
# Display detailed BFD session information.
<SwitchC> display bfd session verbose
Total session number: 1
IPv6 Session working under Ctrl mode:
Local Discr: 17
Source IP: 3001::3
Destination IP: 3000::1
Session State: Up
Min Trans Inter: 500ms
Min Recv Inter: 500ms
Recv Pkt Num: 57
Hold Time: 2200ms
Running Up for: 00:00:06
Protocol: BGP6
Diag Info: No Diagnostic
The output shows that a BFD session is established between Switch A's VLAN-interface 100 and
Switch C's VLAN-interface 101 and that BFD runs properly.
Display IPv6 peer information on Switch C, and you can see that the neighborship between Switch
A and Switch C is established.
<SwitchC> display bgp ipv6 peer
BGP local router ID : 1.1.1.1
Local AS number : 200
Total number of peers : 2
Peer
2000::1
3000::1
# Display route 1200::0/64 on Switch C.
<SwitchC> display ipv6 routing-table 1200::0 64 verbose
Routing Table :
Summary Count : 2
Destination : 1200::
NextHop : 3000::1
RelayNextHop : 3001::2
Up session number: 1
Remote Discr: 13
Interface: Vlan-interface101
Act Trans Inter: 500ms
Act Detect Inter: 3000ms
Send Pkt Num: 53
Connect Type: Direct
Auth mode: none
Peers in established state : 2
AS MsgRcvd MsgSent OutQ PrefRcv Up/Down
200 7
200 7
356
Init mode: Active
10 0 0 00:01:05 Established
10 0 0 00:01:34 Established
PrefixLength : 64
Preference
Tag
State
: 255
: 0H