HP MSR2000 series Configuration Manual page 27

Figure 3 Network diagram
Configuration procedure
Configure IP addresses and subnet masks for interfaces on the switches. (Details not shown.)
1.
Configure static routes on Switch S, Switch A, and Switch D so that Switch S can reach Loopback
2.
0 on Switch D and Switch D can reach Loopback 0 on Switch S:
# Configure static routes on Switch S.
<SwitchS> system-view
[SwitchS] ip route-static 4.4.4.4 32 vlan-interface 200 13.13.13.2
[SwitchS] ip route-static 4.4.4.4 32 vlan-interface 100 12.12.12.2 preference 65
# Configure static routes on Switch D.
<SwitchD> system-view
[SwitchD] ip route-static 1.1.1.1 32 vlan-interface 200 13.13.13.1
[SwitchD] ip route-static 1.1.1.1 32 vlan-interface 101 24.24.24.2 preference 65
# Configure static routes on Switch A.
<SwitchA> system-view
[SwitchA] ip route-static 4.4.4.4 32 vlan-interface 101 24.24.24.4
[SwitchA] ip route-static 1.1.1.1 32 vlan-interface 100 12.12.12.1
Configure static route FRR:
3.
# Configure Switch S.
[SwitchS] bfd echo-source-ip 1.1.1.1
[SwitchS] ip ip-prefix abc index 10 permit 4.4.4.4 32
[SwitchS] route-policy frr permit node 10
[SwitchS-route-policy] if-match ip-prefix abc
[SwitchS-route-policy] apply fast-reroute backup-interface vlan-interface 100
backup-nexthop 12.12.12.2
[SwitchS-route-policy] quit
[SwitchS] ip route-static fast-reroute route-policy frr
# Configure Switch D.
[SwitchD] bfd echo-source-ip 4.4.4.4
[SwitchD] ip ip-prefix abc index 10 permit 1.1.1.1 32
[SwitchD] route-policy frr permit node 10
[SwitchD-route-policy] if-match ip-prefix abc
[SwitchD-route-policy] apply fast-reroute backup-interface vlan-interface 101
backup-nexthop 24.24.24.2
[SwitchD-route-policy] quit
[SwitchD] ip route-static fast-reroute route-policy frr
Verify the configuration:
4.
14