Configuring An Ipv6 Bgp Route Reflector - HP MSR2000 series Configuration Manual

Step
4. Advertise COMMUNITY
attribute to an IPv6 peer or
peer group.
5. Advertise extended
community attribute to an IPv6
peer or peer group.
Applying a routing policy to routes advertised to a peer or peer group
Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 address family
view.
4. Apply a routing policy to
routes advertised to an IPv6
peer or peer group.

Configuring an IPv6 BGP route reflector

Follow these guidelines when you configure an IPv6 BGP route reflector:
Because the route reflector forwards routing information between clients, you must make clients of a route
reflector fully meshed. If clients are fully meshed, HP recommends disabling route reflection between
clients to reduce routing costs.
If a cluster has multiple route reflectors, you must specify the same cluster ID for these route reflectors to
avoid routing loops.
To configure an IPv6 BGP route reflector:
Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 address family
view.
4. Configure the router as a route
reflector and specify an IPv6
peer or peer group as a client.
5. Enable route reflection
between clients.
6. Configure the cluster ID of the
route reflector.
Command
peer { ipv6-group-name |
ipv6-address }
advertise-community
peer { ipv6-group-name |
ipv6-address }
advertise-ext-community
Command
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address } route-policy
route-policy-name export
Command
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address } reflect-client
reflect between-clients
reflector cluster-id cluster-id
342
Remarks
Not advertised by default.
Not advertised by default.
Remarks
N/A
N/A
N/A
Not applied by default.
Remarks
N/A
N/A
N/A
Not configured by default.
Optional.
Enabled by default.
Optional.
By default, a route reflector uses its
router ID as the cluster ID.