Enabling Ospf; Configuration Prerequisites - HP MSR2000 series Configuration Manual

Task
Tuning and optimizing
OSPF networks
Configuring OSPF FRR
Configuring OSPF
Graceful Restart
Configuring BFD for OSPF

Enabling OSPF

You must enable OSPF before performing other OSPF configuration tasks.

Configuration prerequisites

Configure the link layer protocol, and IP addresses for interfaces so that neighboring nodes can reach
each other.
Configuring OSPF route redistribution
Configuring OSPF packet timers
Specifying LSA transmission delay
Specifying SPF calculation interval
Specifying the LSA arrival interval
Specifying the LSA generation interval
Disabling interfaces from receiving and sending OSPF
packets
Configuring stub routers
Configuring OSPF authentication
Adding the interface MTU into DD packets
Configuring the maximum number of external LSAs in LSDB
Enabling compatibility with RFC 1583
Logging neighbor state changes
Configuring OSPF network management
Enabling message logging
Enabling the advertisement and reception of opaque LSAs
Configuring OSPF to give priority to receiving and processing
hello packets
Configuring the LSU transmit rate
Setting the DSCP value for OSPF packets
Enabling OSPF ISPF
Configuring the OSPF GR Restarter
Configuring the OSPF GR Helper
Triggering OSPF Graceful Restart
72
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional