HP MSR2000 series Configuration Manual page 445

Destination: 2002:1::/64
NextHop : 2002:1::1
Interface : Vlan20
Destination: 2002:1::1/128
NextHop : ::1
Interface : InLoop0
Destination: 2012::/64
NextHop : FE80::20F:E2FF:FE3E:9CA2
Interface : Vlan20
Destination: FE80::/10
NextHop : ::
Interface : NULL0
The output shows that the MCE has learned the private route of VPN 2. The MCE maintains the
routes of VPN 1 and VPN 2 in two different routing tables. In this way, routes from different VPNs
are separated.
Configure routing between the MCE and PE 1.
3.
# On the MCE, configure the port connected to PE 1 as a trunk port, and configure it to permit
packets of VLAN 30 and VLAN 40 to pass with VLAN tags.
[MCE] interface gigabitethernet 1/0/3
[MCE-GigabitEthernet1/0/3] port link-type trunk
[MCE-GigabitEthernet1/0/3] port trunk permit vlan 30 40
[MCE-GigabitEthernet1/0/3] quit
# On PE 1, configure the port connected to MCE as a trunk port, and configure it to permit packets
of VLAN 30 and VLAN 40 to pass with VLAN tags.
[PE1] interface gigabitethernet 1/0/1
[PE1-GigabitEthernet1/0/1] port link-type trunk
[PE1-GigabitEthernet1/0/1] port trunk permit vlan 30 40
[PE1-GigabitEthernet1/0/1] quit
# On the MCE, create VLAN 30 and VLAN-interface 30, bind VLAN-interface 30 with VPN
instance vpn1 and configure an IPv6 address for the VLAN-interface 30.
[MCE] vlan 30
[MCE-vlan30] quit
[MCE] interface vlan-interface 30
[MCE-Vlan-interface30] ip binding vpn-instance vpn1
[MCE-Vlan-interface30] ipv6 address 30::1 64
[MCE-Vlan-interface30] quit
# On the MCE, create VLAN 40 and VLAN-interface 40, bind VLAN-interface 40 with VPN
instance vpn2 and configure an IPv6 address for the VLAN-interface 40.
[MCE] vlan 40
[MCE-vlan40] quit
[MCE] interface vlan-interface 40
[MCE-Vlan-interface40] ip binding vpn-instance vpn2
432
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : RIPng
Preference: 100
Cost : 1
Protocol : Direct
Preference: 0
Cost : 0