Ospfv3 Configuration Examples; Configuring Ospfv3 Areas - HP MSR2000 series Configuration Manual

Task
Display OSPFv3 statistics.
Display the GR status of the
specified OSPFv3 process.

OSPFv3 configuration examples

Configuring OSPFv3 areas

Network requirements
In Figure 106, all switches run OSPFv3. The AS is split into three areas, in which, Switch B and Switch C
act as ABRs to forward routing information between areas.
Configure Area 2 as a stub area in order to reduce LSAs in the area without affecting route reachability.
Figure 106 Network diagram
Configuration procedure
Configure IPv6 addresses for interfaces. (Details not shown.)
1.
Configure OSPFv3 basic functions:
2.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] ospfv3
[SwitchA-ospfv3-1] router-id 1.1.1.1
[SwitchA-ospfv3-1] quit
[SwitchA] interface vlan-interface 300
[SwitchA-Vlan-interface300] ospfv3 1 area 1
[SwitchA-Vlan-interface300] quit
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] ospfv3 1 area 1
[SwitchA-Vlan-interface200] quit
# Configure Switch B.
<SwitchB> system-view
Command
display ospfv3 statistics [ | { begin | exclude | include }
regular-expression ]
display ospfv3 [ process-id ] graceful-restart status [ |
{ begin | exclude | include } regular-expression ]
291
Remarks
Available in
any view
Available in
any view