Configuring Routing Between Mce And Pe - HP MSR2000 series Configuration Manual

Step
6. Redistribute remote site routes
advertised by the PE.
Configure a filtering policy to
7.
filter the routes to be
advertised.
8. Configure a filtering policy to
filter the received routes.
NOTE:
After you configure a VPN site as an IBGP peer of the MCE, the MCE does not advertise the BGP routes
learned from the VPN site to other IBGP peers, including VPNv4 peers. Only when you configure the VPN
site as a client of the RR (the MCE), does the MCE advertise routes learned from it to other IBGP peers.
Configure a VPN site:
2.
Step
1. Enter system view.
2. Enter BGP view.
3. Configure the MCE as the
IBGP peer.
4. Redistribute the IGP routes of
the VPN.

Configuring routing between MCE and PE

MCE-PE routing configuration includes these tasks:
Bind the MCE-PE interfaces to VPN instances
•
Perform route configurations
•
Redistribute VPN routes into the routing protocol running between the MCE and the PE.
•
Configuring static routing between MCE and PE
Step
1. Enter system view.
Command
import-route protocol [ process-id
| all-processes ] [ med med-value |
route-policy route-policy-name ] *
filter-policy { acl-number |
ip-prefix ip-prefix-name } export
[ direct | isis process-id | ospf
process-id | rip process-id | static ]
filter-policy { acl-number |
ip-prefix ip-prefix-name } import
Command
system-view
bgp as-number
peer { group-name | ip-address }
as-number as-number
import-route protocol [ process-id ]
[ med med-value | route-policy
route-policy-name ] *
Command
system-view
403
Remarks
By default, no route redistribution
is configured.
Optional.
By default, BGP does not filter the
routes to be advertised.
Optional.
By default, BGP does not filter the
received routes.
Remarks
N/A
N/A
N/A
Optional.
A VPN site must advertise the VPN
network addresses it can reach to
the connected MCE.
Remarks
N/A