Configuring The Interface Behavior; Configuring A Rip Version - HP MSR2000 series Configuration Manual

RIP configurations made in interface view before enabling RIP take effect after RIP is enabled.
•
• RIP runs only on the interfaces residing on the specified networks. Specify the network after
enabling RIP to validate RIP on a specific interface.
You can enable RIP on all interfaces using the command network 0.0.0.0.
•
If a physical interface is attached to multiple networks, you cannot advertise these networks in
•
different RIP processes.
To enable RIP:
Step
1. Enter system view.
2. Enable a RIP process and
enter RIP view.
3. Enable RIP on the interface
attached to the specified
network.

Configuring the interface behavior

Step
1. Enter system view.
2. Enter RIP view.
3. Disable an interface from
sending routing updates.
4. Return to system view.
5. Enter interface view.
6. Enable the interface to receive
RIP messages.
7. Enable the interface to send
RIP messages.

Configuring a RIP version

You can configure a RIP version in RIP view or interface view under the following conditions.
If neither global nor interface RIP version is configured, the interface sends RIPv1 broadcasts and
•
can receive the following packets: RIPv1 broadcast, RIPv1 unicast, RIPv2 broadcast, RIPv2 multicast,
and RIPv2 unicast.
If an interface has no RIP version configured, it uses the global RIP version; otherwise it uses the RIP
•
version configured on it.
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
network network-address
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
silent-interface { interface-type
interface-number | all }
quit
interface interface-type
interface-number
rip input
rip output
25
Remarks
N/A
Disabled by default.
Disabled by default.
Remarks
N/A
N/A
Optional.
By default, all interfaces can send
routing updates.
The disabled interface can still
receive updates.
N/A
N/A
Optional.
Enabled by default.
Optional.
Enabled by default.